engineering-drawings
Engineering drawings
Make drawings a builder or inspector can use without guessing. Treat visual clarity, technical correctness, and completeness as separate acceptance requirements. Do not substitute a polished illustration for an engineering document. For review-only work, report findings and required corrections without modifying or uploading artifacts unless requested.
Choose the document
Establish the intended use and accepted baseline before drawing: functional schematic, physical termination diagram, arrangement/assembly drawing, or dimensioned part drawing. Preserve requested functions and revision scope; do not add hardware or redesign an accepted part to make a sheet easier to draw.
- For wiring and termination work, read electrical.
- For housings, physical parts, and 2D views of 3D parts, read mechanical.
- For a required convention or compliance claim, consult standards.
Reuse known inputs. Ask only for missing information that controls the next consequential decision. Mark unresolved information where it affects interpretation; continue independent work. A concept may omit unresolved details if clearly limited; a build/inspection drawing may not silently depend on them.