dual-led-constant-power

Installation
SKILL.md

Dual LED Constant Power

Use this skill for the two-LED Arduino/MOS/INA219 setup where the goal is smooth spectral modulation while keeping measured total electrical power approximately constant.

Default workflow

  1. Prefer the calibrated LUT controller over RL or fast feedback.
  2. Confirm I2C sees the Waveshare monitor at 0x40, 0x41, 0x42, and 0x43.
  3. Upload firmware/dual_led_constant_power_lut/dual_led_constant_power_lut.ino.
  4. Capture with scripts/capture_dual_led_power_plot.py.
  5. Inspect the runtime section of the plot, not only the calibration sweeps.
  6. Commit and push firmware, documentation, and lightweight final measurement outputs when working inside the repo.

Hardware assumptions

Use Arduino UNO with two YYNMOS-1 MOS modules and Waveshare Current/Power Monitor HAT.

Important monitor wiring:

Installs
1
GitHub Stars
1
First Seen
Oct 19, 2026